Bintelli Edge Specifikace stáhnout pdf (Strana 57)

57

2A

Default Point Set Example

2B

Countertop Example

If the lines involved in the perimeter drawing are not

correct check the point definitions tab to see if the

points are defined according to the instructions under

the Point Definition Tab.

If the default parameters of the drawing are incorrect,

such as radius, overhang, wall offset, etc; check the

setting tab.

2C

Open Wall Example

If the lines involved in the perimeter drawing are not

correct check the point definitions tab to see if the

points are defined according to the instructions under

the Point Definition Tab.

If the default parameters of the drawing are incorrect,

such as radius, overhang, wall offset, etc; check the

setting tab.

Available output formats:

Standard DXF

Planit ORD Ver 2

ETemplate Design File (EDF)

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 66 67

Komentáře k této Příručce

Žádné komentáře